Figure 5a illustrates the Ferrostatin-1 mw field this website emission measurement system. The field emission measurements were performed in a vacuum chamber with a base pressure of about 6 × 10−6 Torr at room temperature. The inter-electrode distance between the probe and the sample was controlled using a precision screw meter. The Keithley 237 high-voltage source-measurement unit was used to provide the sweeping electric field

to record the corresponding emission currents. Figure 5b shows the electric field emission performance of InSb nanowires and describes the field emission current density dependence on applied electric fields. The field emission properties can be analyzed by the F-N theory [39] as is listed below: (6) where E (E = V/d) expresses the applied electric field, V represents the applied voltage, Φ is the work function of the material,

β is the field enhancement factor, and A and B are constants, where A = 1.56 × 10−10 (A V−2 eV) and B = 6.83 × 103 (eV−3/2 V m−1) [39]. In previous works, the turn-on field defines the current density of 1 μA cm−2[39]. The turn-on field MK-1775 ic50 (E on) of InSb nanowires in this work is therefore 1.84 V μm−1. The obtained E on value of InSb nanowires is excellent compared to the value of other reported materials via the thermal reactive process, such as SnO2/Sb nanowires (4.9 V μm−1) [40], SiC nanowires (5 V μm−1) [41], carbon nanotubes (4 V μm−1) [42], and AlN nanotips (3.9 V μm−1) [43]. Additionally, in order to generate enough brightness (>1,000 cd m−2) for an electronic device (i.e., display) under practical operation, the current density shall reach 0.1 mA cm−2[39]. Thus, the threshold field (E th) of InSb nanowires is around 3.36 V μm−1, so the generated current density can achieve enough brightness. Compared to the above-described materials via the thermal reactive process, this work synthesized InSb nanowires that not only exhibited excellent characteristics but also provided the advantages of room-temperature synthesis and a large area without

expensive vacuum equipment. Figure 5 Field emission measurement system, J – E field emission curve, and surface band diagram of InSb nanowires. (a) The schematic diagram of field emission measurement system. (b) J-E field emission curve. The turn-on N-acetylglucosamine-1-phosphate transferase field of InSb nanowires is 1.84 V μm−1 at 1 μA cm−2, and the threshold field of InSb nanowires is 3.36 V μm−1 at 0.1 μA cm−2. Inset: F-N plot reveals the field emission behavior that follows F-N theory. (c) Schematic of the surface band diagram of the InSb nanowires. The F-N emission behavior can be observed by plotting the ln(J/E 2) versus 1/E curve, shown in the inset of Figure 5b. The linear curve implies that the field emission behavior of nanowires follows the F-N theory. Based on the F-N theory, the field enhancement factor β of InSb nanowires can be calculated. According to the work function of InSb (4.57 eV) [44], the field enhancement factor β is regarded as 20,300.