Methods A metal/HfO2/Au NCs/SiO2/Si (A1) structure was fabricated. P-type Si with a doping level of 8.33 × 1017 cm−3 was used as a substrate. A 3-nm-thick thermal SiO2 oxide was fabricated using a rapid thermal annealing
(RTA) device after pre-gate cleaning. An Au film with a thickness of approximately 1 nm was sputtered using SCD005 (Balzers Union, Balzers, Liechtenstein) with a sputtering time of 2 s. The Semaxanib ic50 sample was then annealed in N2 ambient using the RTA device. Annealing was performed at 600°C for 10 s Selleckchem CB-839 to form Au NCs. A 30-nm HfO2 film deposited by the electron beam (E-beam) evaporation system with a base pressure of 3.6 × 10−6 Torr served as the blocking layer. After depositing the TaN/Al metal gate electrode with thicknesses of 50/300 nm and the Cr/Au bottom electrode with thicknesses of 20/200 nm through magnetron Screening Library mouse sputtering, the capacitive structure of the NC memory device was finally completed. Metal/HfO2/SiO2/Si (A2), metal/SiO2/Au NCs/SiO2/Si (A3), and metal/HfO2 (PDA)/Au NCs/SiO2/Si (A4) were fabricated using the same process, with the exception of a 20-nm SiO2 film deposition using the E-beam for sample A3 and the annealing of HfO2 after deposition at 400°C for 10 min in the O2 ambient for sample A4. XPS with a 1,486.6-eV Al Kα source was used to obtain composition information about the as-deposited and annealed HfO2 film.
The electrical characteristics of the NC memory devices were measured in the parallel mode using a Keithley 4200 semiconductor characterization system (Cleveland, OH, USA) and a Keithley 590 C-V analyzer at room temperature. Results and discussion Figure 1 shows the cross-sectional high-resolution transmission electron microscopy (HRTEM) micrograph of the A1 device. The Au NCs formed on the 3-nm thermal SiO2 are covered with a 30-nm HfO2 layer. The NC density is approximately 8 × 1011 cm−2, wherein the size is mainly distributed from 6 to 8 nm. The charging
properties are described from the C-V measurements at 1 MHz with a step of 0.1 V/s for A1 (Figure 2a). Double C-V sweeps are Edoxaban performed with voltage sweeps from inversion to accumulation, i.e., from positive to negative bias and back to inversion to give prominence to the charge trapping in the Au NCs. Electron and hole trapping in the NCs are enabled by the positive and negative biases, respectively. The positive flat band voltage shifts (ΔV) correspond to an increase in electron trapping, whereas the negative ΔV corresponds to the increase in hole trapping given the increasing sweep voltage range. Figure 2a shows that the negative ΔV is about 1.05 V, whereas the positive ΔV is close to 0, which indicates that no additional electrons can be trapped with the increase in the sweep range. The inset plot in Figure 2a shows the C-V curves of sample A2.