The adsorbent prepared in the present study, however, is essentially microporous, even though the impregnation rate was high. Such difference is attributed to the raw material employed for production of our adsorbent (coffee press cake) being originally less porous than the SCG employed by Reffas et al. (2010), which Epacadostat in vitro were already submitted to carbonization during coffee roasting procedure. Furthermore, our impregnation time (3 min) was significantly shorter than that employed for activation of SCGs (3 h). It is noteworthy to mention that phenylalanine

molecules are relatively small (0.7 × 0.5 × 0.5 nm) and thus the produced micropores (2 nm average diameter) should be accessible to this amino acid. The functional groups at the surface of the adsorbent, characterized by the Boehm method, were predominantly acid, distributed as phenolic (2.94 mmol/gsorbent), carboxylic (2.31 mmol/gsorbent) and lactonic (0.22 mmol/gsorbent). The amount of basic groups was 0.23 mmol/gsorbent. The titration curves for evaluation of the

pHPZC converged to a value of 2.7, and therefore the adsorbent surface will be negatively charged for solution pHs greater than 2.7. The low pHPZC value is in agreement with the predominance of surface acid groups (acidic activation). Predominance of phenolic and carboxylic surface groups was also reported for other adsorbents prepared by H3PO4 activation at temperatures of 350 and 450 °C, with corresponding pHPZC values of 2 and 3.7 (Prahas, Kartika, Indraswati, & Ismaji, 2008; Reffas et al., 2010). Carbonization http://www.selleckchem.com/products/Roscovitine.html of coffee press cake without chemical activation provided adsorbents with higher pHPZC values of 7.9 and 12, with the lower value associated with milder carbonization Aspartate conditions and a predominance of phenolic surface groups (Franca et al., 2010) and the higher value associated with higher carbonization

temperatures and predominance of basic surface groups (Nunes et al., 2009). Results on the effects of particle size, initial pH and adsorbent dosage are shown in Fig. 2. Phenylalanine uptake was expected to increase with the decrease in particle size, due to the corresponding increase in surface area and better accessibility to pores. However, as the particle diameter was reduced below 0.50 mm, there was a decrease in adsorption efficiency (Fig. 2a). Such behavior was due to the finer particles being suspended in the solution surface, thus hindering proper mixing of the adsorbent and adsorbate. Hence, the remaining experiments were conducted with the adsorbent particle diameter in the range 0.50 < D < 0.84 mm. Amino acids have both amine and carboxylic acid groups, presenting both acid and base characteristics. Thus, changes in solution pH are expected to affect the adsorption mechanism and the extent in which PHE will be adsorbed onto the solid surface. Phenylalanine presents dissociation constants pK1 = 1.83 and pK2 = 9.13 and isoelectric point pI = 5.48 (Belitz, Grosch, & Schieberle, 2009).